Manifestations     Conservatory Films    Residential    Speciality/Decorative    DDA Solutions    Designs    Trade Partners    Contact us

 
   
Office Partition Manifestation & Graphics

Your office partition glass divides each office from the next, so why not create a pattern or choose from a selection of ready made designs for your manifestation graphics and use these to add some character to your work environment, add a focal point, while at the same time adding privacy to those meeting rooms.

The internal partition glass could be frosted or etched - choose from full frost to a pattern or design, we can mix different films and colours to create eye catching designs, while adding privacy to the level you require.

We can carry-out a site survey (depending on location & size of job) and discuss your requirements, we can further assist with design options & project manage For complete satisfaction we provide a professional installation service, which will not disrupt your office

We also manufacture & install DDA compliant graphics

Using the latest print technology we can now print window wallpaper onto frosted, contravision (micro-perforated), solid prints & more....


Various works completed

 

   
 

Relevant regulations

It is a legal requirement to have all relevant existing glazing made impact-safe and be so marked.

In addition the Building Regulations BS 6262 Part 4, Safety, Human Impact states that:

  • Every window or glazed area in a wall, partition, door, or gate shall be of safety material or be protected against breakage -ie, it should not break on impact or should break safely.

  • Safety glazing material must meet BS 6206 Class B in doors and side panels over 900mm wide, and Class C in those less than 900mm wide. Low level glazing must meet a minimum of BS 6206 Class C.

  • This entails the use of laminated, toughened or safety-wired glass, or plastic glazing sheet that meet BS 6206, or glass with plastic film applied so that the pane of glass with the film meets BS 6206 Class A or B.

  • Existing glazing must also be appropriately marked or featured so as to make it apparent and thus avoid the risk of collision because it is not properly visible.

  • In particular, large uninterrupted areas of glazing where people might reasonably think they can walk straight through.

 

Which glazing is affected?

'Critical locations' is the term given to describe of internal and external walls, doors and partitioning which are of primary concern in terms of glazing safety. These areas are depicted here and described in the two categories below:

Critical locations are:

Between the finished floor level and 1500mm (shoulder height) above that level in doors, and in side panels which fall within 300mm of either edge of the door.

Between the finished floor level and 800mm (waist height) above that level in the case of walls, partitions and windows.

It is important to note that any part of a glass pane affected must meet the requirements in its entirety and not just in the relevant section.

To find our more about this range of products, simply complete the form in the Contact Us section or call us, where we will be only too happy to discuss your requirements

 

 Manifestations      Conservatory Films      Offices & Partitions      Automotive      Designs      DIY      Contact us 

 
     

Copyright 2010-2015 - www.glassfrosting.co.uk - All Rights Reserved

 
 
 

 
 
 
 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 
  Products
  About Window Films
  Commercial Solutions
  Residential Solutions
  Hospitals / Care Homes
  Privacy Films
  Safety Bomb Blast Films
  Frosted & Etched Films
  Offices & Partitions
  Manifestation Graphics
  Speciality Films
  Tinted / Coloured Films
  Conservatories
  Automotive Films
  DDA Solutions
  Lumisty
  Anti Graffiti
  Printed Wallpaper
   
   
  Trade Partners
  Installation Service
  Designs
  Signage
   
  Home DIY
  Case Studies
  Enquiry
  Contact Us